Installation Procedure
- Install the battery carrier.
Tighten: Tighten the 3 bolts to 15 N.m (11 lb ft).
- Install the 2 cable ties.
- Insert the battery.
- Install the battery shield.
Install the 2 shield, battery carrier.
Tighten: Tighten the bolt to 10 N.m (89 lb in).
- Install the battery holder.
Tighten: Tighten the bolt to 7 N.m (62 lb in).
- Connect the battery.
- Connect the positive cable.
- Connect the ground cable.
- For programming procedures, refer to Control Module References .
CAUTION:
Refer to Fastener Caution
.