LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2008 >> Vue Red Line, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 868 (Rear Suspension System) >> Repair Instructions >> Support Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: When transferring any suspension components, refer to each suspension component replacement procedure for the proper torque specifications.
  1. Install the rear stabilizer shaft assembly on the support. Refer to Stabilizer Shaft Replacement .
    2. Fig 1: Identifying Upper Control Arm To Knuckle Bolt & Nut
    GM1835765Courtesy of GENERAL MOTORS CORP.
  2. Install the upper control arm on the support.
  3. Install the upper control arm nuts and bolts to the support. Refer to Rear Axle Upper Control Arm Replacement .
    4. Fig 2: Identifying ABS Routing Harness Connectors
    GM1835586Courtesy of GENERAL MOTORS CORP.
  4. Install the wheel speed sensor wiring harness on the upper control arms and the support.
  5. Secure the rear support to a transmission jack stand.
  6. Raise the support into position with the aide of an assistant.
    7. Fig 3: Identifying Support Assembly To Body Bolts (Sedan/Coupe)
    GM1835959Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  7. Install the support mounting bolts.

    Tighten:  Tighten the support mounting bolts to 100 N.m (74 lb ft). Using the J 45059  , rotate the support mounting bolts an additional 30 degrees.

  8. Remove the transmission jack from the support.
  9. Install the knuckle assembly to the support. Refer to Knuckle Replacement .
  10. Install the upper shock absorber nuts. Refer to Shock Absorber Replacement .
  11. Install the lower control arm assembly. Refer to Rear Axle Lower Control Arm Replacement .
  12. Install the toe links to the support. Refer to Toe Link Replacement .
    13. Fig 4: Locating Park Brake Cable Retaining Bracket & Bolt
    GM2014401Courtesy of GENERAL MOTORS CORP.
  13. Install the park brake cable retaining bolt (3), park brake cable (1), on the trailing arm assemblies (2).
  14. Install the rear wheel speed sensor wiring harness to the right rear trailing arm mounting bracket.
  15. Reconnect the wheel speed sensor electrical connector at the right rear trailing arm.
  16. Install the rear muffler assembly. Refer to Muffler Replacement (LY7) or Muffler Replacement (With LAT, LE5 or LZ4) or Muffler Replacement (LE5 With MH8) .
  17. Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
  18. Lower the vehicle.
  19. Realign the rear suspension. Refer to Wheel Alignment Measurement .
scientia non olet · About LEMON Manuals