LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2008 >> Vue Red Line, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1520 (Antilock Brake System) >> Diagnostic Information and Procedures >> DTC C0110 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2012 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the EBCM.
  2. Ignition OFF and all vehicle systems OFF. It may take up to 2 minutes for all vehicle systems to power down. Test for less than 10 Ω between the ground circuit terminal 1 and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal 13 and ground.
    • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
  4. If all circuits test normal, replace the brake pressure modulator valve and verify DTC does not reset. If the DTC resets replace the EBCM.
scientia non olet · About LEMON Manuals