LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2008 >> Vue Red Line, AWD >> Repair and Diagnosis >> Brakes >> Anti-Lock Brake System, Traction Control System & Stability Control System >> Diagnostic Information and Procedures >> DTC C0460 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the steering angle sensor.
  2. Test for less than 5 ohms between the low reference circuit terminal 6 and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the EBCM.
  3. Ignition ON, verify a test lamp illuminates between the B+ circuit terminal 1 and ground.
    • If less than the specified value, test the ignition circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the EBCM.
  4. Ignition OFF, disconnect the harness connector at the EBCM.
  5. Ignition ON, test for 0 volts between the CAN bus low circuit terminal 4 and ground at the steering angle sensor connector.
    • If greater than the specified value, test the CAN bus low circuit for a short to voltage.
  6. Test for 0 volts between the CAN bus high circuit terminal 3 and ground.
    • If greater than the specified value, test the CAN bus high circuit for a short to voltage.
  7. Test for infinite resistance between the CAN bus low circuit terminal 4 and the CAN bus high circuit terminal 3.
    • If not the specified value, test the CAN bus circuits for a short to together.
  8. If all circuits test normal, replace the steering angle sensor.
scientia non olet · About LEMON Manuals