LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2008 >> Vue Red Line, AWD >> Repair and Diagnosis >> Brakes >> Anti-Lock Brake System, Traction Control System & Stability Control System >> Diagnostic Information and Procedures >> DTC C0110 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the EBCM.
  2. Test for less than 5 ohm of resistance between the ground circuit terminal 16 and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify that a test lamp illuminates between the B+ circuit terminals 1 and 32 and ground.
    • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal and the B+ circuit fuse is open, test or replace the BPMV.
  4. Ignition OFF, remove the EBCM from the BPMV.
  5. Inspect the EBCM to BPMV connector for no damage, corrosion, or presence of brake fluid.
    • If connector corrosion or damage is evident, replace BPMV and/or EBCM as necessary.
    • If brake fluid is present, replace both BPMV and EBCM.
  6. If all circuits test normal, replace the BPMV.
scientia non olet · About LEMON Manuals