LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2008 >> Sky Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Fuel Tank Pressure Sensor
    GM1594372Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel tank pressure sensor (2).
    2. Fig 2: Locating Fuel Tank Electrical Connectors
    GM1594359Courtesy of GENERAL MOTORS CORP.
  2. Connect the fuel tank pressure sensor electrical connector (5).
    3. Fig 3: View Of Fuel Sending Unit Access Cover & Bolts
    GM1594369Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the fuel pump module access cover.
  4. Install the access cover bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  5. Install the rear compartment trim panel. Refer to Rear Compartment Trim Panel Replacement .
scientia non olet · About LEMON Manuals