LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2008 >> Aura Green Line >> Repair and Diagnosis >> Brakes >> Anti-Lock Brake System, Traction Control System & Stability Control System >> Repair Instructions >> Brake Fluid Pressure Sensor Replacement

Brake Fluid Pressure Sensor Replacement

Fig 1: View Of Brake Fluid Pressure Sensor
GM1563324Courtesy of GENERAL MOTORS CORP.
Callout Component Name
CAUTION: Remove all the air from the hydraulic brake system anytime the hydraulic brake system is opened for repair. The entire bleeding procedure must be followed. Failure to remove all the air in the hydraulic brake system will result in reduced braking performance and possible personal injury.
CAUTION: Refer to Brake Fluid Irritant Caution .
NOTE: Refer to Brake Fluid Effects on Paint and Electrical Components Notice .
1 Brake Fluid Pressure Sensor Electrical Connector
Procedure: 
Thoroughly clean the area around the brake fluid pressure sensor of any dirt or foreign material.
2 Brake Fluid Pressure Sensor
NOTE: Refer to Fastener Notice .

Procedure

  1. After the installation is complete, bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Pressure) or Hydraulic Brake System Bleeding (Manual) .
  2. Turn the ignition switch to the ON position. DO NOT start the engine.
  3. Perform the Diagnostic System Check - Vehicle .

    Tighten:  17 N.m (13 lb ft)
scientia non olet · About LEMON Manuals