Installation Procedure

Install the pressure sensor fuel tank.
- Attach the pressure sensor fuel tank to the bracket.
- Connect the wiring harness plug to the pressure sensor fuel tank.
With the aid of an assistant, position fuel tank to the vehicle.

NOTE: Refer to Fastener Notice .

Install the 2 fuel tank holding straps.
Tighten: Tighten the 4 fuel tank holding strap bolts to 23 N.m (17 lb ft).
Extend the jack.
Install the parking brake cable to the bracket in 7 places.
Attach the rear fuel lines to the middle fuel lines.
Connect the 2 quick-release fittings
Attach the fuel filler tube to the fuel tank.
Tighten: Tighten the fuel filler tube clamp to 3.5 N.m (31 lb in).
Attach the vent hose to the vent pipe.
Connect the quick-release fitting.
Connect the wiring harness plug of the fuel tank fuel pump module.
Install the complete exhaust system. Refer to Exhaust System Replacement .
Connect the wiring harness of the pressure sensor (atmospheric pressure) to the fuel filler tube.
Install the 3 cable ties.
Lower the vehicle halfway.
Connect the wiring harness of the pressure sensor (atmospheric pressure).
- Connect the wiring harness plug.
- Install the 3 cable ties.
Install the right rear wheel housing inner paneling.
Tighten:
- Tighten the 2 rear wheel housing inner paneling nuts to 2.5 N.m (22 lb in).
- Tighten the 2 rear wheel housing inner paneling bolts to 2.5 N.m (22 lb in).
Mount the right rear wheel.
Lower the vehicle halfway.
Install the right rear wheel.
Tighten: Tighten the right rear wheel bolt to 110 N.m (81 lb ft).
Connect the battery.
Connect the ground clamp to the ground terminal.

Tighten: Tighten the ground clamp nut to 5 N.m (44 lb in).
For programming procedures, refer to Control Module References .
Close the hood.