Removal Procedure
- Set the tires in a straight-ahead position. Center the steering wheel.
- Disable the SIR. Refer to SIR Disabling and Enabling .
- Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
- Remove the instrument panel left insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
- Remove the SIR module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
- Remove the steering wheel. Refer to Steering Wheel Replacement .
- Remove the SIR coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement .
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (2.2L (L61) and 3.5L (L66)) or Battery Negative Cable Disconnection and Connection (2.4L (LAT)) .
- Disconnect the electrical connector and depress the locking tabs to remove the turn signal multifunction switch.
- Disconnect the electrical connector and depress the locking tabs to remove the wipers/washer switch.
- Disconnect the ignition housing electrical connectors.
- Disengage the retaining tabs on the park lock cable assembly. Remove the assembly from the ignition module.
- Remove the 2 multifunction housing to ignition housing bolts.
- Slide the multifunction housing off the steering column.
- Disconnect the electric power steering (EPS) electrical connectors from the EPS controller.
- Remove the lower steering column mounting bolt.
- Remove and discard the column to I-shaft bolt.
- Remove the 2 upper steering column attachment bolts.
- Remove the steering column from the vehicle.
NOTE:
Rotating steering wheel while it is disconnected from the steering gear may cause damage to SIR coil.
IMPORTANT:
If you are installing the removed column, index mark the column to the I-shaft connection for reassembly alignment.