Installation Procedure
WARNING: This page is about a different car, the 2008 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Install the negative cable.
- Position the negative battery cable terminal (6) in front of the engine harness ground terminal (5).
- Install the engine harness ground lead bolt (1).
Tighten: Tighten the bolt to 25 N.m (18 lb ft).
- Install the radiator lower air baffle. Refer to Radiator Air Lower Baffle and Deflector Replacement .
- Lower the vehicle.
- Install the negative cable to the retainers.
- Install tape holding the positive cable to the negative cable.
- Install the negative battery cable clip (3) to the battery tray.
- Install the negative cable ground terminal nut at the tie bar.
Tighten: Tighten the nut to 10 N.m (89 lb in).
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (LZ4, LY7, and LE5) or Battery Negative Cable Disconnection and Connection (LAT) .
NOTE:
Refer to Fastener Notice
.