Window Motor
WARNING: This page is about a different car, the 2010 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the appropriate window motor.
- Install a 30A fused jumper wire between the control terminal A and 12 volts. Momentarily install a jumper wire between the control terminal B and ground. The window motor should perform the UP/DOWN function
- If the function does not perform as specified, replace the window motor.
- Reverse the jumper wires. The window motor should perform the DOWN/UP function.
- If the function does not perform as specified, replace the window motor.