LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2007 >> Vue Green Line >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Repair Instructions >> Inflatable Restraint Sensing and Diagnostic Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: CPA Electrical Connectors, Nuts & SDM
    GM934648Courtesy of GENERAL MOTORS CORP.
  1. Remove any dirt, grease, or other contaminants from the mounting surface.
    2. NOTE: Refer to Fastener Notice .
  2. Install the SDM to the vehicle with the nuts.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  3. Install the console assembly. Refer to Front Floor Console Replacement .
  4. Enable the SIR system. Refer to SIR Disabling and Enabling .
    5. IMPORTANT: If you do NOT perform the body control module (BCM) programming procedure, the vehicle option content information which is read by the BCM may be incorrect and a DTC B1001 Option Configuration Error will set in both the SDM and the BCM. This will illuminate the AIR BAG telltale.
  5. Reprogram the BCM. Refer to Body Control Module Programming and Setup .
  6. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals