Installation Procedure
WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Position the power steering pump inlet pipe/hose to the vehicle.
- Compress the clamp (1) and connect the power steering inlet pipe/hose (2) to the cooler pipe (3).
- Install the power steering pump inlet pipe routing bolt from the engine block.
Tighten: Tighten the power steering pump inlet pipe/hose routing bolt to 10 N.m (89 lb in).
- Remove the right side engine splash shield. Refer to Engine Splash Shield Replacement .
- Lower the vehicle.
- Position the power steering pump inlet pipe/hose to the routing clip and install the nut.
Tighten: Tighten the power steering pipe/hose routing clip nut to 10 N.m (89 lb in).
- Compress the clamp and connect the power steering pump inlet pipe/hose to the power steering reservoir.
- Remove the drain pan from under the vehicle.
- Install the drive belt. Refer to Drive Belt Replacement .
- Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
- Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
NOTE:
Refer to Fastener Notice
.