LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2007 >> Sky Red Line, Standard >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls & Fuel - 2.0L - Introduction (2 Of 2) >> Repair Instructions >> Engine Control Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Upper And Lower Retaining Tabs
    GM1828318Courtesy of GENERAL MOTORS CORP.
  1. Slide the ECM into the bracket.
  2. Push down on the ECM until the upper and lower retaining tabs (1, 2) snaps into place.
    3. Fig 2: Locating ECM
    GM1828317Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine harness electrical connectors (1, 3) to the ECM.
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  5. Reset the clock and preset radio stations.
  6. If a NEW ECM was installed, the ECM must be programmed. Refer to Control Module References .
scientia non olet · About LEMON Manuals