LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2007 >> Sky Red Line, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Wiring Systems & Power Management) >> Repair Instructions >> Ignition and Start Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac Solstice. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Ignition Switch
    GM854768Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the ignition switch and screws on to the steering column.

    Tighten:  Tighten the screws to 2 N.m (17 lb in).

  2. Connect the ignition switch harness connector.
  3. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
    IMPORTANT: If the ignition switch is replaced and a learn procedure is not performed, the engine will crank but not start or will start and stall immediately.
  4. Perform the vehicle theft deterrent system learn procedure. Refer to Control Module References .
scientia non olet · About LEMON Manuals