LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2007 >> Sky Base, Standard >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management >> Repair Instructions >> Ignition Lock Cylinder Case Replacement >> Installation Procedure

Installation Procedure

  1. Install the ignition lock cylinder into the lock cylinder housing. Refer to Ignition Lock Cylinder Replacement .
    2. Fig 1: View Of Ignition Lock Cylinder Case
    GM854922Courtesy of GENERAL MOTORS CORP.
  2. Install the lock cylinder case housing to the steering column.
    3. Fig 2: View Of Shear Bolt
    GM1499716Courtesy of GENERAL MOTORS CORP.
  3. Install the lock cylinder case housing clamp and a new shear bolt. Ensure the tab is correctly positioned.
    4. IMPORTANT: Ensure the lock cylinder case mounting clamp tab is properly installed. Rock the lock cylinder case back and forth to ensure it is seated into the lock bolt cutout.
  4. Tighten the shear bolt until the head breaks off.
    5. Fig 3: View Of Ignition Switch Harness Connector
    GM854934Courtesy of GENERAL MOTORS CORP.
  5. If applicable, connect the ignition lock cylinder solenoid harness connector.
  6. Connect the ignition switch harness connector to the lock module.
    7. Fig 4: Steering Wheel Module
    GM1551347Courtesy of GENERAL MOTORS CORP.
  7. Install the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement .
  8. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  9. Install the steering wheel. Refer to Steering Wheel Replacement (good cell) .
scientia non olet · About LEMON Manuals