Installation Procedure
WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Install the regulator to the lock module.
- Lubricate the motor drive gear and the regulator sector teeth.
- Install the window counter balance spring stud to the module and turn 1/4 turn to lock in place.
- Snap the power window motor to the lock module in order to install the power window motor.
- Use the J 38864 in order to install the spring tension. See Special Tools . Walk up the spring tension.
- Connect the wiring harness to the regulator motor.
- Remove the tape from the door glass and position the glass.
- Slide the window sash onto the door glass.
- Install the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
- Install the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
IMPORTANT:
Ensure the marker or grease pencil line from the removal procedure is lined up. Lining up the mark will set the correct pre-tension of the counterbalance spring.