LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2007 >> Sky Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Antilock Brake System, Traction Control System & Stability Control System) >> Diagnostic Information and Procedures >> Traction Off Indicator Inoperative >> Test Description

Test Description

WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

The number below refers to the step number on the diagnostic table.

  1. 6:  This step tests if the instrument panel cluster (IPC) is able to turn ON the Traction Off indicator.
Traction Off Indicator Inoperative

Step Action Yes No
Schematic Reference: Antilock Brake System Schematics 
Connector End View Reference: Antilock Brake System Connector End Views  or Displays and Gages Connector End Views
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2
  1. Turn OFF the ignition for 5 seconds.
  2. Turn ON the ignition while observing the Traction Off indicator.
Does the Traction Off indicator illuminate for 2 seconds and then turn OFF?
Go to Diagnostic Aids Go to Step 3 
3
  1. Disconnect the harness connector of the traction control system (TCS) switch.
  2. Ground the TCS signal circuit at the TCS harness connector.
Does the Traction Off indicator illuminate?
Go to Step 4  Go to Step 5 
4 Replace the TCS switch. Refer to Traction Control Switch Replacement .
Did you complete the replacement?
Go to Step 9  -
5 Test for an open in the TCS switch signal circuit. Refer to Circuit Testing .
Did you find and correct the condition?
Go to Step 9  Go to Step 6 
  1. Install a scan tool.
  2. Select the Instrument Panel Cluster (IPC) Special Functions menu on the scan tool.
  3. Command the IPC lamps ON.
Does the Traction Off indicator turn ON?
Go to Step 8  Go to Step 7 
7 Replace the IPC. Refer to Control Module References for replacement, setup, and programming.
Did you complete the replacement?
Go to Step 9  -
8 Replace the body control module (BCM). Refer to Control Module References for replacement, setup, and programming.
Did you complete the replacement?
Go to Step 9  -
9
  1. Turn OFF the ignition for 5 seconds.
  2. Turn ON the ignition while observing the Traction Off indicator.
Does the Traction Off indicator illuminate for 2 seconds and then turn OFF?
System OK Go to Step 2