LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2007 >> Sky Base, Automatic >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Battery Hold Down Retainer
    GM1593200Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not tip the battery more than 40 degrees during battery installation.
  1. Install the battery.
    2. NOTE: Refer to Fastener Notice .
  2. Install the battery hold down retainer and bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    3. Fig 2: Front Fender Rear Bracket
    GM1593322Courtesy of GENERAL MOTORS CORP.
  3. Install the front fender rear bracket.
  4. Install the front fender rear bracket to side rail bolts.

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

    5. Fig 3: Front Fender Rear Bracket
    GM1593324Courtesy of GENERAL MOTORS CORP.
  5. Install the front fender to front fender rear bracket upper (1) and lower (2) bolts.

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

    6. Fig 4: Identifying Battery Connections
    GM1593197Courtesy of GENERAL MOTORS CORP.
  6. Install the positive battery cable (1).
  7. Tighten the positive battery cable nut.

    Tighten:  Tighten the nut to 17 N.m (13 lb ft).

  8. Close the positive battery cable connection cover.
  9. Install the wheelhouse liner. Refer to Front Wheelhouse Liner Replacement (Turbo) or Front Wheelhouse Liner Replacement (Base) .
  10. Connect the negative battery cable (2). Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals