LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2007 >> Relay 3.9 1 >> Repair and Diagnosis >> Steering >> Steering Wheel And Steering Column >> Repair Instructions >> Steering Wheel Replacement >> Installation Procedure

Installation Procedure

  1. If equipped, install the controls and the control harness to the steering wheel.
    2. Fig 1: Steering Wheel, Shaft & Nut
    GM294367Courtesy of GENERAL MOTORS CORP.
  2. Install the wiring through the steering wheel.
  3. Install the steering wheel.
  4. Connect the steering wheel control electrical connector.
    5. NOTE: Refer to Fastener Notice .
  5. Install the steering wheel nut.

    Tighten:  Tighten the nut to 41 N.m (30 lb ft).

  6. Install the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
  7. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals