LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2007 >> Relay 3.9 1 >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Disc Brake System) >> Repair Instructions >> Rear Brake Caliper Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean and visually inspect threads of the caliper bracket bolts (2) and mounting holes in the knuckle.
    Fig 1: View Of Caliper Bracket Bolts
    GM785076Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: To ensure that the proper clamp load will be present when installed. It is imperative that the threads on the caliper bracket bolts, as well as the mounting holes in the knuckle, be cleaned of all debris and inspected before proceeding with installation.
  2. Apply threadlocker, GM P/N 12345493 (Canadian P/N 10953488), or equivalent to the threads of the brake caliper bracket bolts (2).
  3. Install the caliper bracket (1) with the bracket bolts (2).

    Tighten:  Tighten the caliper bracket bolts to 120 N.m (88 lb ft).

    NOTE: Refer to Fastener Notice .
  4. Install the rear brake pads.
  5. Install the caliper. Refer to Rear Brake Caliper Replacement .
scientia non olet · About LEMON Manuals