LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2007 >> Relay 3.9 1 >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Negative Cable Replacement >> Removal Procedure

Removal Procedure

IMPORTANT: When replacing battery cables, be sure to use replacement cables that are the same type, gage, and length.
    Fig 1: Disconnecting/Reconnecting Battery Current Sensor Electrical Connector
    GM1533512Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Disconnect the instrument panel (I/P) wiring harness electrical connector (2) from the battery current sensor (1).
    3. Fig 2: View Of Battery & Cables
    GM1544743Courtesy of GENERAL MOTORS CORP.
  3. Open the positive battery cable cover (5).
  4. Loosen the positive battery cable nut (3).
  5. Remove the positive battery cable from the battery.
    6. Fig 3: Negative Battery Cable Ground
    GM1680886Courtesy of GENERAL MOTORS CORP.
  6. Remove the negative battery cable ground terminal nut (1) from the inner fender stud.
  7. Remove the negative battery cable ground (2) from the stud.
    8. Fig 4: Junction Block Cover
    GM1680883Courtesy of GENERAL MOTORS CORP.
  8. Open the junction block cover (1).
    9. Fig 5: Locating Battery Positive Cable Nut & Cable
    GM1544745Courtesy of GENERAL MOTORS CORP.
  9. Remove the positive battery cable to junction block nut (1).
  10. Remove the I/P wiring harness (4) terminal and the positive battery cable (3) terminal from the junction block stud (2).
    11. Fig 6: Remove/Install Battery Cable At Starter
    GM1679419Courtesy of GENERAL MOTORS CORP.
  11. Remove the radiator air baffle. Refer to Radiator Air Baffle Assemblies and Deflectors .
  12. Remove the starter motor "BAT" terminal nut (5).
  13. Remove the positive battery cable from the starter motor "BAT" terminal.
    14. Fig 7: Locating Engine Harness Grounds
    GM1679875Courtesy of GENERAL MOTORS CORP.
  14. Remove the engine harness ground nut (2).
  15. Remove the engine harness ground terminal.
  16. Remove the negative battery cable from the transaxle stud.
    17. Fig 8: View Of Cable Retainers
    GM1544744Courtesy of GENERAL MOTORS CORP.
  17. Remove the battery cable conduit retainers from the inner fender (1) and the lower tie bar (2).
  18. Remove the negative and positive battery cables from the vehicle.
  19. Separate the negative and positive battery cables.
  20. Remove the battery current sensor. Refer to Battery Current Sensor Replacement .
scientia non olet · About LEMON Manuals