Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Relay. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Mirror Case Jackscrews & Mirror Motor

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: The jackscrew springs must be positioned on the fingers, opposite the ball end, to compress the fingers.

Push the jackscrews into the mirror motor.

Fig 2: View of Jackscrews in Mirror Face

Courtesy of GENERAL MOTORS CORP.

Rotate both jackscrews to position the ball flanges to be in line with the attaching hub. They will then be correctly positioned to the mirror face.

Fig 3: Locating Heated Mirror Face Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the heated mirror face electrical connector, if equipped.
Connect the rearview mirror turn signal indicator electrical connector, if equipped.
Align the wire stabilizers, if equipped, on the mirror case to the motor. Also align the mirror case to the motor.

Fig 4: Mirror Glass & Motor

Courtesy of GENERAL MOTORS CORP.

With the palm of your gloved hand, press firmly on the center of the glass until the case seats onto the motor.
With the palm of you gloved hand pivot the mirror face to engage the jackscrews.
The jackscrews will give a clicking noise when properly seated.
Inspect the mirror operation and clean the glass face.