LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2007 >> Ion Red Line >> Repair and Diagnosis >> Steering >> Steering Wheel And Steering Column >> Repair Instructions >> Steering Column Replacement >> Installation Procedure

Installation Procedure

  1. If replacing the steering column duplicate the scribed mark placed on the old column.
    2. Fig 1: View Of Ignition Lock Cylinder Case
    GM854922Courtesy of GENERAL MOTORS CORP.
  2. Install the ignition lock cylinder case to the steering column. Refer to Ignition Lock Cylinder Case Replacement .
    3. Fig 2: View Of Steering Column
    GM854962Courtesy of GENERAL MOTORS CORP.
  3. Position the steering column in the vehicle.
  4. Hand start the steering column mid-pivot bolt.
  5. Hand start the steering column mounting bolts.
    6. NOTE: Refer to Fastener Notice .
  6. Tighten the column bolts using the following order:

    Tighten: 

    1. Tighten the mid-pivot bolt to 25 N.m (18 lb ft).
    2. Tighten the RH column mounting bolt to 25 N.m (18 lb ft).
    3. Tighten the LH column mounting bolt to 25 N.m (18 lb ft).

    7. Fig 3: View Of EPS Control Module Harness Connectors
    GM854947Courtesy of GENERAL MOTORS CORP.
  7. Connect the EPS control module power feed harness connector.
  8. Connect the EPS control module small harness connector.
    9. Fig 4: Scribing Marks On Intermediate Shaft-To-Steering Column Connection
    GM854943Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: For proper realignment of the steering column to intermediate shaft, use the previously scribed marks.
  9. Slide the intermediate shaft onto the steering column while aligning the previously scribed marks.
  10. If the steering column to intermediate shaft was not previously scribed. Refer to Intermediate Steering Shaft Replacement .
    11. Fig 5: View Of Upper Intermediate Shaft Pinch Bolt And Column
    GM854769Courtesy of GENERAL MOTORS CORP.
  11. Install a new intermediate shaft pinch bolt.

    Tighten:  Tighten bolt to 34 N.m (25 lb ft).

    12. Fig 6: View Of Ignition Switch Harness Connector
    GM854934Courtesy of GENERAL MOTORS CORP.
  12. Connect the ignition lock cylinder harness connector.
  13. Connect the ignition switch harness connector.
    14. Fig 7: View Of SIR Coil Assembly
    GM854958Courtesy of GENERAL MOTORS CORP.
  14. Install the SIR coil module assembly. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement .
    15. Fig 8: View Of SIR Coil Module Assembly Harness Connectors
    GM854953Courtesy of GENERAL MOTORS CORP.
  15. Connect the SIR coil harness connector to the SIR coil module assembly.
  16. Connect the wiper/washer harness connector to the SIR coil module assembly.
  17. Connect the head lamp/turn signal harness connector to the SIR coil module assembly.
  18. Install the upper and lower shroud. Refer to Steering Wheel Shroud Replacement .
  19. Install the I/P lower compartment. Refer to Steering Column Opening Filler Replacement .
  20. Install the steering wheel. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals