LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2007 >> Ion Red Line >> Repair and Diagnosis >> Steering >> Steering Wheel And Steering Column >> Repair Instructions >> Steering Column Jacket Replacement >> Installation Procedure

Installation Procedure

    IMPORTANT: The column shaft splines must be free of dirt and debris.
  1. Clean the column shaft splines
  2. Use the supplied grease to apply 2 grams (0.07 ounces) of grease to the column shaft splines.
    3. Fig 1: View Of Upper Jacket
    GM854910Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the new jacket on the steering column.

    Tighten:  Tighten the bolts to 11 N.m (97 lb in).

    4. Fig 2: View Of Steering Column
    GM854962Courtesy of GENERAL MOTORS CORP.
  4. Install the steering column mounting bolts.

    Tighten: 

    1. Tighten the RH bolt to 25 N.m (18 lb ft).
    2. Tighten the LH bolt to 25 N.m (18 lb ft).

  5. Install the I/P lower compartment. Refer to Steering Column Opening Filler Replacement .
  6. Install the ignition lock cylinder case. Refer to Ignition Lock Cylinder Case Replacement .
  7. Install the SIR coil module assembly. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement .
  8. Install the column trim covers. Refer to Steering Column Trim Covers Replacement (Except Redline)  or Steering Column Trim Covers Replacement (Redline) .
  9. Install the steering wheel. Refer to Steering Wheel Replacement .
  10. Road test the vehicle to verify steering operation.
scientia non olet · About LEMON Manuals