LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2007 >> Ion Red Line >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn Ion Red Line, 2005 Saturn Ion 3, 2005 Saturn Ion 2, and 2005 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Do not tip the battery more than 40 degrees during battery installation.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the battery to the battery tray.
  2. Install the battery brace (2) and the brace bolt.

    Tighten:  Tighten the battery brace bolt to 25 N.m (18 lb ft).

  3. Install the battery hold down retainer (1) and bolt.

    Tighten:  Tighten the battery hold down retainer bolt to 18 N.m (13 lb ft).

    4. Fig 1: View Of Battery Hold Down Retainer & Brace
    GM1066340Courtesy of GENERAL MOTORS CORP.
  4. Connect the battery vent assembly.
  5. Connect the positive battery cable bolt (1).

    Tighten:  Tighten the battery positive cable terminal bolt to 17 N.m (13 lb ft).

    6. Fig 2: View Of Battery & Battery Cables
    GM868001Courtesy of GENERAL MOTORS CORP.
  6. Connect the negative battery cable bolt (2). Refer to Battery Negative Cable Disconnect/Connect Procedure .
scientia non olet · About LEMON Manuals