LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2007 >> Ion Red Line >> Repair and Diagnosis >> External Pages >> Different car >> Section 94 (Supplemental Inflatable Restraint System) >> Repair Instructions >> SIR Disabling and Enabling Zone 5 >> Enabling Procedure

Enabling Procedure

WARNING: This page is about a different car, the 2005 Saturn Ion Red Line, 2005 Saturn Ion 3, 2005 Saturn Ion 2, and 2005 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the key from the ignition switch.
  2. Connect the I/P module connector (1) to the vehicle harness connector (2).
    3. Fig 1: Identifying I/P Module Connector To Vehicle Harness Connector
    GM816857Courtesy of GENERAL MOTORS CORP.
  3. Install the CPA to the I/P module connector (2).
  4. Install the right outer trim cover to the I/P (3). Refer to Instrument Panel (I/P) Trim Panel Replacement - Right in Instrument Panel, Gages and Console.
  5. Install the AIR BAG fuse into the body control module fuse center.
    6. Fig 2: Locating Air Bag Fuse
    GM893538Courtesy of GENERAL MOTORS CORP.
  6. Install the body control module fuse center cover.
  7. Use caution while reaching in and turn the ignition switch to the ON position.

    The AIR BAG indicator will flash then turn OFF.

  8. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About LEMON Manuals