LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2007 >> Ion Red Line >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Controls (Introduction)) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement (SCIP) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Saturn Ion Red Line. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: Use the new SCIP sensor seal provided with the new SCIP sensor.
  1. Install the SCIP sensor (1) into the intake manifold.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  2. Connect the SCIP sensor harness connector.
    3. Fig 1: Locating SCIP Sensor & BARO Sensor
    GM1389393Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals