LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2007 >> Ion Red Line >> Repair and Diagnosis >> Electrical >> Instrument Panel System Displays And Gauges >> Repair Instructions >> Instrument Cluster Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Cluster
    GM877776Courtesy of GENERAL MOTORS CORP.
  1. Position the cluster in the vehicle and connect the cluster electrical connector.
    2. Fig 2: View Of Cluster Screws
    GM877777Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the cluster screws

    Tighten:  Tighten the cluster screws to 2.5 N.m (22 lb in).

    3. Fig 3: View Of Cluster Trim Plate
    GM877802Courtesy of GENERAL MOTORS CORP.
  3. Align the cluster trim plate retaining fasteners with the center trim panel.
  4. Push on the outer edge of the cluster trim plate in order to secure the retaining fasteners.
  5. Install the screw retaining the cluster trim plate to the center trim panel.

    Tighten:  Tighten the cluster trim plate screw to 2.5 N.m (22 lb in).

    6. Fig 4: View Of Accessory Trim Plate Electrical Connectors
    GM877774Courtesy of GENERAL MOTORS CORP.
  6. Connect the accessory trim plate electrical connector(s).
    7. Fig 5: Instrument Panel Bezel/Trim Plate
    GM877771Courtesy of GENERAL MOTORS CORP.
  7. Align the retaining fasteners with the I/P.
  8. Push on the outer edge of the accessory trim plate in order to secure the retaining fasteners.
  9. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals