LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2007 >> Aura Green Line >> Repair and Diagnosis >> Steering >> Steering Wheel And Steering Column >> Repair Instructions >> Steering Wheel Position Sensor Replacement >> Removal Procedure

Removal Procedure

    IMPORTANT: If replacing the steering wheel position sensor, the new sensor MUST come with a locating pin installed. If a locating pin is not installed, return and reorder a new steering wheel position sensor. Do not apply force to the steering wheel position sensor in a sideways direction.
    When reusing the steering wheel position sensor you must install a locating pin before removing it from the steering column. If the steering wheel position sensor loses its correct position it must be discarded.
    The locating pin diameter must be in the range of 1.0-2.0 mm.
    Fig 1: View Of Special Tool J 42640
    GM333146Courtesy of GENERAL MOTORS CORP.
  1. Set the front wheels in the straight-ahead position and install anti-rotation pin J 42640  in the steering column lower access hole.
    2. Fig 2: Identifying Intermediate Shaft
    GM1654921Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the intermediate steering shaft from the steering column. Refer to Intermediate Steering Shaft Replacement .
  3. Disconnect any electrical connectors as needed.
  4. Remove the steering wheel position sensor.
scientia non olet · About LEMON Manuals