Circuit/System Testing
CAUTION:
Refer to SIR Caution
.
IMPORTANT:
It is recommended that Component Testing be performed before Circuit Testing when diagnosing steering wheel controls.
- Ignition OFF, disconnect the harness connector at the left and right steering wheel control switches.
- Ignition ON, Radio ON, test for 6.5-9 volts between the voltage circuit and ground at the right switch harness connector.
- If less than 6.5 volts, test the voltage circuit for short to ground or open/high resistance. If circuit tests normal, replace the radio.
- If greater than 9 volts, test the voltage circuit for short to voltage. If circuit tests normal, replace the radio.
- Test for 6.5-9 volts from the voltage circuit and toggle to the signal circuits at the left and right switch harness connectors.
- If less than 6.5 volts, test the signal circuit for an open/high resistance. If circuit tests normal, replace the radio.
- If greater than 9 volts, test the signal circuit for short to voltage. If circuit tests normal, replace the radio.
- Ignition OFF, reconnect the right switch.
- Ignition ON, Radio ON, test for 6.5-9 volts between the voltage circuit and the left switch and ground at the left switch harness connector.
- If less than 6.5 volts, test the voltage circuit to the left switch for a short to ground or open/high resistance. If the circuit tests normal, refer to component testing.
- If greater than 9 volts, test the voltage supply circuit for the left switch for a short to B+.
- Pressing the right switch, test for 1-5 volts between the signal circuit and ground at the left switch harness connector.
- If less than 1 volt, test the signal circuit for a short to ground.
- If all circuits test normal, refer to component testing.