Conditions for Running the DTC
DTCs P0030, P0036, P0068, P0069, P0097, P0098, P0101, P0102, P0103, P0106, P0107, P0108, P0117, P0118, P0120, P0121, P0125, P0128, P0130, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P0140, P0141, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0442, P0443, P0446, P0449, P0452, P0453, P0461, P0496, P1133, P1516, P1681, P2101, P2135, or P2176 are not set.
Passive Test
- The engine is running.
- The Engine Run Time parameter is less than 13.3 minutes.
- DTC P0136 runs the passive test once per drive cycle when the above conditions have been met for 2 seconds.
Intrusive Test
- The Engine Run Time parameter is more than 13.3 minutes.
- The ignition 1 Signal parameter is between 11-18 volts.
- The Mass Airflow (MAF) Sensor parameter is between 14-100 g/s.
- The Engine Speed parameter is between 1,000-5,000 RPM.
- The Vehicle Speed parameter is between 30-130 km/h (19-81 mph).
- The Short Term FT parameter is between -20 and +20 percent.
- The maximum number of intrusive attempts is less than 50.
- The passive test did not pass.
- DTC P0136 runs the intrusive test once per drive cycle when the above conditions are met.