Installation Procedure

Fig 1: View Of Stop Lamp Switch

Courtesy of GENERAL MOTORS CORP.

Connect the stop lamp switch electrical connector.
Insert the stop lamp switch into the retainer.
NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 2: View Of Accelerator Pedal
Courtesy of GENERAL MOTORS CORP.
Install the accelerator pedal to the dash panel. Install the retaining nuts.
Tighten: Tighten the accelerator pedal retaining nuts to 10 N.m (89 lb in).
Adjust the stop lamp switch. Refer to Stop Lamp Switch Adjustment .