LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Ion 2 4D Sedan, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 2.2L - Introduction (2 Of 2) >> Repair Instructions >> Ignition Control Module Replacement >> Installation Procedure

Installation Procedure

Fig 1: View Of ICM
GM783965Courtesy of GENERAL MOTORS CORP.
IMPORTANT: Make sure the interconnect and seal are lined up before module installation.
  1. Install the ignition control module in the ignition coil housing.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the ICM retaining screws.

    Tighten:  Tighten the retaining screws to 1.5 N.m (13 lb in).

  3. Connect the ICM harness connector.
  4. Install the accelerator cable bracket.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the accelerator cable bracket bolt.

    Tighten:  Tighten the retaining screws to 10 N.m (18 lb in).

  6. Install the accelerator cable to the bracket.
scientia non olet · About LEMON Manuals