LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2005 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1176 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> DTC B1019 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2012 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:

When removing the connectors inspect for damage or corrosion. Damage or corrosion to the following requires repair or replacement of the affected:

  • SDM
  • SDM wiring harness connector
  1. With a scan tool verify the BCM is programmed with the correct VIN.
  2. Ignition OFF, disconnect the harness connectors at the SDM. Verify the connector is not damaged and has no bent or damaged pins, terminals or shorting bars.
    • If damage is found, repair as necessary and perform the Setup New SDM procedure.
  3. Connect the harness connector at the SDM.
  4. Ignition ON, verify the scan tool system configuration matches the components installed on the vehicle.
    • If the system configuration is not correct, reprogram the SDM with the correct components.
  5. Ignition ON, clear all PPS module and SDM DTCs.
  6. Verify DTC B1019 does not set.
    • If DTC sets, replace the SDM.
scientia non olet · About LEMON Manuals