LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2005 >> Vue Base, 2.2 D, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Engine Controls (Introduction) - 3.4L (La1)) >> Repair Instructions >> Accelerator Controls Cable Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Am and 2004 Oldsmobile Alero. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Accelerator Cable Bracket
    GM12689Courtesy of GENERAL MOTORS CORP.
  1. Install the accelerator cable bracket to the throttle body.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nuts and bolts.

    Tighten: 

    • Tighten the bolts to 10 N.m (89 lb in).
    • Tighten the nut to 13 N.m (115 lb in).

    3. Fig 2: Accelerator Cable & Accelerator Cable Bracket
    GM294522Courtesy of GENERAL MOTORS CORP.
  3. Connect the accelerator cable into the accelerator cable bracket.
  4. Connect the accelerator cable cross slug to the throttle body slots.
    5. Fig 3: Identifying Cruise Control Cable
    GM319387Courtesy of GENERAL MOTORS CORP.
  5. If applicable connect the cruise control cable to the throttle lever and accelerator bracket.
scientia non olet · About LEMON Manuals