Installation Procedure

Position the left console trim panel.

Fig 1: Removing/Installing Front Console Trim Panels
Courtesy of GENERAL MOTORS CORP.
Install the push-in fastener.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screws to the left console trim panel.
Tighten: Tighten the screws to 2.5 N.m (22 lb. in.).
Position the steering column filler panel.
Install the screws to the filler panel.
Tighten: Tighten the screws to 2.5 N.m (22 lb. in.).

Fig 2: View Of Knee Bolster (Filler Panel) & Screws
Courtesy of GENERAL MOTORS CORP.
Position the center trim plate to the front console.

Fig 3: Removing/Installing Center Trim Plate
Courtesy of GENERAL MOTORS CORP.
Push until the trim clips engage.
Install the center trim bezel to the console. Refer to Trim Bezel Replacement - Center .
Lift the rear of the center floor console.
Connect the electrical connector to the auxiliary power outlet.

Fig 4: View Of Auxiliary Power Outlet Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Reposition the center console.
Install the cup holder screw.
Tighten: Tighten the screws to 2.5 N.m (22 lb. in.).
Install the cup holder liner.

Fig 5: Removing/Installing Cup Holder Liner
Courtesy of GENERAL MOTORS CORP.
Reach under the front seats to access the lower console screws.
Install the center console screws.
Tighten: Tighten the screws to 2.5 N.m (22 lb. in.).

Fig 6: Locating Console Screws
Courtesy of GENERAL MOTORS CORP.
Position the front seat forward to the original position.