LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2005 >> Relay FWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Repair Instructions >> SIR Disabling and Enabling Zone 9 >> Enabling Procedure

Enabling Procedure

  1. Remove the key from the ignition.
  2. When enabling the side impact module - RF proceed to step 17, if the entire SIR system needs to be enable then go to step 3.
    3. Fig 1: View Of Seat Belt Pretensioner Connector And Wiring Harness Routing
    GM899818Courtesy of GENERAL MOTORS CORP.
  3. Connect the vehicle wiring harness connector to the left seat belt retractor pretensioner.
  4. Install the CPA to the left seat belt retractor pretensioner connector.
  5. Install the left lower center pillar trim cover. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.
    6. Fig 2: Locating Inflatable Restraint Steering Wheel Module Coil Connector
    GM628317Courtesy of GENERAL MOTORS CORP.
  6. Connect the steering wheel module coil yellow connector (1).
  7. Install the CPA to the steering wheel module coil connector (1) located at the base of the steering column.
  8. Install the left I/P insulator panel. Refer to Knee Bolster, Insulator, Molding Replacement - Instrument Panel in Instrument Panel, Gages, and Console.
    9. Fig 3: Exploded View Of Seat Mounting
    GM262991Courtesy of GENERAL MOTORS CORP.
  9. Connect the vehicle harness connector (4) to the LF side impact module yellow connector (1).
  10. Install the CPA to the LF side impact module connector (1).
    11. Fig 4: Identifying Inflatable Restraint IP Module Connector
    GM262989Courtesy of GENERAL MOTORS CORP.
  11. Connect the I/P module yellow connector (1).
  12. Install the CPA (2) to the I/P module connector (1).
  13. Install the right I/P insulator panel. Refer to Knee Bolster, Insulator, Molding Replacement - Instrument Panel in Instrument Panel, Gages, and Console.
    14. Fig 5: View Of Seat Belt Pretensioner Connector And Wiring Harness Routing
    GM899818Courtesy of GENERAL MOTORS CORP.
  14. Connect the vehicle wiring harness connector to the right seat belt retractor pretensioner.
  15. Install the CPA to the right seat belt retractor pretensioner connector.
  16. Install the right lower center pillar trim cover. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.
    17. Fig 6: Exploded View Of Seat Mounting
    GM262991Courtesy of GENERAL MOTORS CORP.
  17. Connect the vehicle harness connector (4) to the RF side impact module yellow connector (1).
  18. Install the CPA to the RF side impact module connector (1).
  19. Install the Air Bag Fuse.
  20. Install the cover for the underhood fuse center.
  21. Use caution while reaching in and turn the ignition switch to the ON position.

    The AIR BAG indicator will flash then turn OFF.

  22. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About LEMON Manuals