Enabling Procedure
- Remove the key from the ignition.
- Connect the I/P module yellow connector (1).
- Install the CPA (2) to the I/P module connector (1).
- Install the right I/P insulator panel. Refer to Knee Bolster, Insulator, Molding Replacement - Instrument Panel in Instrument Panel, Gages, and Console.
- Install the Air Bag Fuse.
- Install the cover for the underhood fuse center.
- Use caution while reaching in and turn the ignition switch to the ON position.
The AIR BAG indicator will flash then turn OFF.
- Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.