LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2005 >> Relay FWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Repair Instructions >> SIR Disabling and Enabling Zone 2 >> Enabling Procedure

Enabling Procedure

  1. Remove the key from the ignition.
    2. Fig 1: View Of Seat Belt Pretensioner Connector And Wiring Harness Routing
    GM899818Courtesy of GENERAL MOTORS CORP.
  2. Connect the vehicle wiring harness connector to the left seat belt retractor pretensioner.
  3. Install the CPA to the left seat belt retractor pretensioner connector.
    4. Fig 2: Locating Side Impact Sensor Connectors
    GM260344Courtesy of GENERAL MOTORS CORP.
  4. Connect the left SIS wiring harness connector (2) to the left SIS (1).
  5. Install the CPA (3) to the SIS connector (1).
  6. Position SIS (1) back inside the center pillar and slide back into place and tighten the SIS fasteners.
  7. Install the left lower center pillar trim cover. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.
  8. Install the Air Bag Fuse.
  9. Install the cover for the underhood fuse center.
  10. Use caution while reaching in and turn the ignition switch to the ON position.

    The AIR BAG indicator will flash then turn OFF.

  11. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About LEMON Manuals