LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2005 >> Relay FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (Antilock Brake System And Traction Control System) >> Repair Instructions >> Wheel Speed Sensor Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac Aztek and 2005 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Hub & Bearing Assembly - Rear
    GM230412Courtesy of GENERAL MOTORS CORP.
  1. Install the hub and bearing assembly (1) to the vehicle. Refer to Wheel Bearing/Hub Replacement - Rear (Front Wheel Drive/Drum) or Wheel Bearing/Hub Replacement - Rear (Disc and AWD) in Rear Suspension.
    2. Fig 2: View Of Wheel Speed Sensor Components
    GM561883Courtesy of GENERAL MOTORS CORP.
  2. Install the rear wheel speed sensor electrical connector.
  3. Install the wheel and tire assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  4. Lower the vehicle.
  5. Turn the ignition switch to the RUN position with the engine off.
  6. Perform the Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About LEMON Manuals