LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2005 >> Relay AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Supplemental Inflatable Restraint System) >> Repair Instructions >> SIR Disabling and Enabling Zone 9 >> Enabling Procedure

Enabling Procedure

WARNING: This page is about a different car, the 2005 Pontiac Aztek and 2005 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the key from the ignition.
  2. When enabling the side impact module - RF proceed to step 13, if the entire SIR system needs to be enable then go to step 3.
    3. Fig 1: View Of Inflatable Restraint Side Impact Sensor And Pretensioner Wiring Harness Connectors
    GM628394Courtesy of GENERAL MOTORS CORP.
  3. Connect the CPA to the left SIS and pretensioner harness connectors (4), if equipped.
  4. Install the CPA (2) to the SIS and pretensioner harness connectors (3).
    5. Fig 2: Locating Inflatable Restraint Steering Wheel Module Coil Connector
    GM628317Courtesy of GENERAL MOTORS CORP.
  5. Connect the steering wheel module coil connector (1).
  6. Install the CPA to the steering wheel module coil connector (1) located at the base of the steering column.
  7. Install the LH insulator panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages, and Console.
    8. Fig 3: Identifying Inflatable Restraint IP Module Connector
    GM262989Courtesy of GENERAL MOTORS CORP.
  8. Connect the I/P module connector (1).
  9. Install the CPA (2) to the I/P module connector (1).
  10. Install the RH insulator panel. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages, and Console.
    11. Fig 4: View Of Inflatable Restraint Side Impact Sensor And Pretensioner Wiring Harness Connectors
    GM628394Courtesy of GENERAL MOTORS CORP.
  11. Connect the right SIS and pretensioner harness connectors (4).
  12. Install the CPA (2) to the SIS and pretensioner harness connectors (4).
    13. Fig 5: View Of Deployment Harness At Side Impact Module
    GM628320Courtesy of GENERAL MOTORS CORP.
  13. Connect the vehicle harness connector to the RF side impact module connector (1).
  14. Install the CPA to the RF side impact module yellow connector (1).
    15. Fig 6: Locating SIR Fuse
    GM628316Courtesy of GENERAL MOTORS CORP.
  15. Install the SIR Fuse.
  16. Install the console accessory wiring junction block access hole cover.
  17. Use caution while reaching in and turn the ignition switch to the ON position.

    The AIR BAG indicator will flash then turn OFF.

  18. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About LEMON Manuals