Enabling Procedure
WARNING: This page is about a different car, the 2005 Pontiac Aztek and 2005 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the key from the ignition.
- Connect the CPA to the SIS and pretensioner harness connectors (4).
- Install the CPA (2) to the SIS and pretensioner harness connectors (3).
- Install the SIR Fuse.
- Install the console accessory wiring junction block access hole cover.
- Use caution while reaching in and turn the ignition switch to the ON position.
The AIR BAG indicator will flash then turn OFF.
- Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.