LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2005 >> Relay AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Passenger Presence System Replacement - Front >> Installation Procedures

Installation Procedures

WARNING: This page is about a different car, the 2005 Pontiac Aztek and 2005 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Seat Cushion Frame Bladder Retainers
    GM811858Courtesy of GENERAL MOTORS CORP.
  1. Install the inflatable restraint passenger presence system to the seat.
  2. Install the push in retainers (1) that hold the bladder to the seat cushion frame.
    3. Fig 2: View Of Electronic Control Unit & Pressure Switch
    GM811855Courtesy of GENERAL MOTORS CORP.
  3. Install the pressure sensor (2) to the bottom of the passenger seat cushion frame.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the bolts that retain the (ECU) (1) to the bottom the passenger seat cushion frame.

    Tighten:  Tighten the bolts to 2 N.m (18 lb in).

  5. Connect the electrical connectors.
  6. Install the seat cushion trim cover and pad. Refer to Seat Cushion Cover Replacement - Front (Aztek) or Seat Cushion Cover Replacement - Front (Rendezvous) in Seats.
  7. Re-zero the inflatable restraint passenger presence system. Refer to Passenger Presence System Rezeroing Procedure  in SIR.
scientia non olet · About LEMON Manuals