Test Description
WARNING: This page is about a different car, the 2005 Pontiac Aztek and 2005 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
The numbers below refer to the step numbers on the diagnostic table.
- 2: This step determines if condition is present.
- 3: This step determines if the switch is at fault.
DTC P0567
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Cruise Control Schematics Connector End View Reference: Cruise Control Connector End Views or Engine Control Module (ECM) Connector End Views in Engine Controls - 3.6L (LY7) |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 |
|
Go to Step 3 | Go to Diagnostic Aids |
| 3 |
|
Go to Step 4 | Go to Step 5 |
| 4 | Test the cruise control resume/accel switch signal circuit for a short to voltage. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 6 |
| 5 | Inspect for poor connections at the harness connector of the multifunction switch. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 7 |
| 6 | Inspect for poor connections at the harness connector of the engine control module (ECM). Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 8 |
| 7 | Replace the multifunction switch. Refer to Multifunction, Turn Signal Switch Replacement
in Steering Wheel and Column. Did you complete the replacement? |
Go to Step 9 | - |
| 8 | Replace the ECM. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 9 | - |
| 9 |
|
Go to Step 2 | System OK |