Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac Aztek and 2005 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Radio Wiring Harness

Courtesy of GENERAL MOTORS CORP.

Install the XM digital radio receiver to the receiver bracket.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the radio receiver nuts.
Tighten: Tighten the nuts to 4 N.m (35 lb in).

Fig 2: Identifying XM Digital Radio Receiver

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector and the antenna connectors to the XM radio receiver.
Install the I/P compartment. Refer to Compartment Replacement - Instrument Panel (I/P) in Instrument Panel, Gages, and Console.
Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup .