Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac Aztek and 2005 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of DVD Player Assembly

Courtesy of GENERAL MOTORS CORP.

Install the DVD player hook (1) into the hook opening.

Fig 2: Identifying DVD Player Wiring Harness & Connector

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Ensure the harness is routed to the right side of the large plastic pin (2) as shown.

Connect the wire connector (1) to the DVD player assembly.
Install the harness retainer to the panel.
Swing the rear part of the assembly to the headliner so that the retainer is seated.

Fig 3: Locating 4 Retaining Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the rear retaining bolts.
Tighten: Tighten the bolts to 9 N.m (80 lb in).

Fig 4: Locating DVD Player Front Retaining Bolts

Courtesy of GENERAL MOTORS CORP.

Move the screen to the open position.
Install the front retaining bolts (2).
Tighten: Tighten the bolts to 9 N.m (80 lb in).
Close the rear screw cover.