Removal Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing 4 Insulator Bolts On Brake Pressure Modulator Valve Bracket

Courtesy of GENERAL MOTORS CORP.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
Remove the left front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
Turn the ignition switch to the OFF position.

Fig 2: Removing 3 Nuts That Attaching Electronic Brake Control Module (EBCM)/brake Pressure Modulator Valve (BPMV)

Courtesy of GENERAL MOTORS CORP.

Remove the 3 nuts that attach the BPMV bracket to the left front wheelhouse.

Fig 3: Removing 4 Insulator Bolts That Attach BPMV To Bracket

Courtesy of GENERAL MOTORS CORP.

Remove the 4 insulator bolts that attach the BPMV to the bracket.
Carefully lift the brake modulator assembly just enough to clear the bracket, then support the assembly.
Remove the bracket from the vehicle.