Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing & Installing Transaxle Output Speed Sensor

Courtesy of GENERAL MOTORS CORP.

Install the O-ring onto the output speed sensor.
Install the output speed sensor into the transaxle case.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the output speed sensor stud.
Tighten: Tighten the speed sensor stud to 11 N.m (8 lb ft).
Connect the electrical connector.
Lower the vehicle.