LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2005 >> Relay AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 211 (Disc Brake System) >> Repair Instructions >> Front Brake Caliper Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Ensuring Caliper Bolt Boots Proper Installation
    GM344282Courtesy of GENERAL MOTORS CORP.
  1. Install the brake caliper bracket (1).
    2. NOTE: Refer to Fastener Notice .
    IMPORTANT: To ensure that the proper clamp load will be present when installed, it is imperative that the threads on the caliper bracket bolts, as well as the mounting holes in the knuckle, be cleaned of all debris and inspected before proceeding with installation.
    Clean and visually inspect the threads of the caliper bracket bolts (2) and the mounting holes in the knuckle.
    Apply GM P/N 12345493 or equivalent to the threads of the brake caliper bracket bolts (2).
  2. Install the brake caliper bracket bolts.

    Tighten:  Tighten the bolts to 185 N.m (137 lb ft).

    3. Fig 2: Locating Brake Caliper Components
    GM177032Courtesy of GENERAL MOTORS CORP.
  3. Install the brake pad retainers (4) to the brake caliper bracket.
  4. Apply a thin coat of high temperature silicone brake lubricant to the brake pad retainers (4) where the brake pads contact the brake pad retainers.
  5. Lubricate the brake caliper bolt boots with high temperature silicone brake lubricant.
  6. Install the brake caliper bolt boots to the brake caliper bracket.
  7. Install the brake pads to the brake caliper bracket.
  8. Install the brake caliper. Refer to Front Brake Caliper Replacement .
scientia non olet · About LEMON Manuals